Jounce Blocks

Jounce Block

The Jounce Block was made to interface with a driveline dynamometer. A gear rack and pinion system shuttles the top section to an offset of ± 250mm from the center position using a servo motor. The offset of the center position is controlled by an analog voltage signal from the driveline dynamometer.

The jounce block is capable of preforming two tasks. Task one is moving to a desired position, then holding at that position while using the servo motor’s brake. Task two is oscillating continuously to the provided offset. The velocity, acceleration, and deceleration of the servo motor can be adjusted to provide the desired frequency of oscillation.

Fill out our contact form today to learn more about our Jounce Block.

Jounce Block Photos

Contact us Today!